Quote:
|
Originally Posted by melchioe
- with Connect not running, plug in Reader, start Connect. Reader shows up in Connect, but SD or Memory Stick never show up (at least not after 30 minutes, then I give up.)
Anyone else have the issue where the card is not seen in Connect if the Reader is already plugged in when Connect it started? This might have some bearing on some of the card issues reported in this thread...
|
I just tested my kensington 2gb SD in this manner. Showed up fine after I entered the lock code, about 5 seconds after the Reader itself showed. I do use the screen lock, and therefore must enter the code each time in Connect to see the Reader drive and the SD card. That might make the critical difference.