MobileRead Forums - View Single Post

melchioe · 12-11-2006, 12:46 PM

My 2G Sandisk works fine, and for grins, I put in a 2G PNY I had sitting around. Both are fully functional out of the box.

However, I have noticed an interesting phenomenon regarding cards - both SD and Memory sticks, and on two different Readers:

- Start Connect, plug in Reader, reader shows up in the Connect software, and a few seconds later, the card shows up in Connect. Everything works fine.

- with Connect not running, plug in Reader, start Connect. Reader shows up in Connect, but SD or Memory Stick never show up (at least not after 30 minutes, then I give up.)

Anyone else have the issue where the card is not seen in Connect if the Reader is already plugged in when Connect it started? This might have some bearing on some of the card issues reported in this thread...

12-11-2006, 12:46 PM	#54
melchioe Addicted Posts: 22 Karma: 10 Join Date: Nov 2006 Location: Wisconsin Device: iPad, Nooks, PRS-505, Kindles, lots of old ones	2G Sandisk works fine, but Connect software is inconsistent with cards My 2G Sandisk works fine, and for grins, I put in a 2G PNY I had sitting around. Both are fully functional out of the box. However, I have noticed an interesting phenomenon regarding cards - both SD and Memory sticks, and on two different Readers: - Start Connect, plug in Reader, reader shows up in the Connect software, and a few seconds later, the card shows up in Connect. Everything works fine. - with Connect not running, plug in Reader, start Connect. Reader shows up in Connect, but SD or Memory Stick never show up (at least not after 30 minutes, then I give up.) Anyone else have the issue where the card is not seen in Connect if the Reader is already plugged in when Connect it started? This might have some bearing on some of the card issues reported in this thread...