once you've run that command once, it should be Ok.
What I was referring to was adding that command to the installer script, so that it's done once at install time. You don't need to do it every time you run FBReader.
There's a lot more to packaging up a piece of software than I had realised, still, I'm getting there!
I'm working on some improvements.
-
FBReader doesn't do fullscreen properly, goes into, but not out of Full Screen. Fixed this.
- A lot of missing keybindings
- the busy LED goes nuts sometimes
From my reading about the forums, these problems have been solved, so I'll check it out
