MobileRead Forums - View Single Post - PRSCustomizer: Customize and personalize your PRS505 Reader

TOKE · 05-28-2009, 02:13 PM

I have new Sony PRS-505 from UK with firmware 1.2. I need polish national letters (ą, ź, ż, ę, etc.) so I used PRSCustomizer v.1.4 to do flash system.
After this I was very happy becouse I have polish letters!!!
But when I connected to USB my PRS-505 is dead: led light red - PRS-505 charge and transfer book from PC to PRS-505. But I need to hard reset becouse buttons and system not response :-(
So I upgrade my firmware to USA v.1.1 (downgrading european 505's to US firmware) and still I have this problem: PRS-505 WORK FINE UNTIL FLASH SYSTEM PRSCustomizer and after customize - connect to PC via USB.

My friend has PRS-505 from USA and version 1.1 works very fine without trouble.

HELP!!!

05-28-2009, 02:13 PM	#673
TOKE Junior Member Posts: 3 Karma: 10 Join Date: May 2009 Device: Sony PRS-505	I have new Sony PRS-505 from UK with firmware 1.2. I need polish national letters (ą, ź, ż, ę, etc.) so I used PRSCustomizer v.1.4 to do flash system. After this I was very happy becouse I have polish letters!!! But when I connected to USB my PRS-505 is dead: led light red - PRS-505 charge and transfer book from PC to PRS-505. But I need to hard reset becouse buttons and system not response :-( So I upgrade my firmware to USA v.1.1 (downgrading european 505's to US firmware) and still I have this problem: PRS-505 WORK FINE UNTIL FLASH SYSTEM PRSCustomizer and after customize - connect to PC via USB. My friend has PRS-505 from USA and version 1.1 works very fine without trouble. HELP!!!