Quote:
Originally Posted by repilo
I had to replace the microSD card with a new one because my Libra 2 was rebooting or freezing every day.
I just had to slide a thin plastic sheet between the top of the SD card and the metal casing to detach it.
The bottom part, where the contacts are, wasn’t glued (obviously), so there was no need to clean it.
Once I was able to remove the old card, I simply inserted the new one.
|
Sounds like you had an easier time getting the card out of the slot than I did. Some of the conformal coating was definitely between the card and the circuit board. I'm sure their application is not consistent--the factory probably feels that "the bigger the gob, the better the job." I also work at a factory where we waterproof seal a product, and that philosophy is definitely how our guys operate, haha