Quote:
Originally Posted by Renate
Since your problem only seems to be the pushbutton top itself maybe you could try to carve yourself a piece out of some hard plastic?
|
From searching around a bit on DuckDuckGo, I found
this Reddit post, which in turn referenced several 3D-printed replacements:
https://cults3d.com/en/3d-model/gadg...on-replacement
https://www.thingiverse.com/thing:6831066
I may wish to try one or more of them if I can find someone with a 3D printer. The first link expressly says "Clara" but also has "Clara HD" in the tags. Are the two models the same board dimensions such that one would fit in the other?
EDIT: I
do have a SleepCover, so I suppose in the worst-case scenario I could follow the advice of "never turn it off, let the sleepcover put it to sleep", but I believe the reason I stopped actually using the sleep mode years ago was that I was getting much worse battery life.