MobileRead Forums - View Single Post

daskraken · 01-03-2025, 09:23 AM

I accidentally left my Tolino Vision 6 in the car outside where it got quite cold. After turning it on, it seemed to work fine at first, but a couple of minutes later the device froze.

Since then I tried every method known to me (soft reset, hard reset, recovery mode, etc.) to get it to boot up again, but it's stuck on the three animated dots during boot. I can't even get to the recovery mode by pressing and holding the down and power button (for a minute). All it does is flash black/white and then gets stuck on the boot dots again. Does this sound like a faulty SD card or is there something else I could try before breaking the thing open? The device has the stock firmware and I didn't tinker with it in any way. Thanks a lot!

01-03-2025, 09:23 AM	#29
daskraken Junior Member Posts: 6 Karma: 10 Join Date: Jan 2025 Device: Tolino Vision 6	I accidentally left my Tolino Vision 6 in the car outside where it got quite cold. After turning it on, it seemed to work fine at first, but a couple of minutes later the device froze. Since then I tried every method known to me (soft reset, hard reset, recovery mode, etc.) to get it to boot up again, but it's stuck on the three animated dots during boot. I can't even get to the recovery mode by pressing and holding the down and power button (for a minute). All it does is flash black/white and then gets stuck on the boot dots again. Does this sound like a faulty SD card or is there something else I could try before breaking the thing open? The device has the stock firmware and I didn't tinker with it in any way. Thanks a lot!