Thread: Go6 unboxing
View Single Post
Old 10-09-2024, 07:14 PM   #2
Renate
Onyx-maniac
Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.Renate ought to be getting tired of karma fortunes by now.
 
Posts: 3,955
Karma: 17500001
Join Date: Feb 2012
Device: Nook NST, Glow2, 3, 4, '21, Kobo Aura2, Poke3, Poke5, Go6
All you astute people have noticed already that the circuit board says "Poke6".

Opening the case on this is much tougher than the Poke5.
It takes quite a bit of force to open it.

This has a different processor than anything we've seen, an SM6115.
But it's part of the "Bengal" family so the same SDM662 Firehose loader works.
Currently I'm doing a full, raw backup. Done.
That way, no matter how I screw it up I can recover it.

The UART and EDL test points are as shown.
Attached Thumbnails
Click image for larger version

Name:	poke6c.png
Views:	397
Size:	403.2 KB
ID:	211292  
Renate is offline   Reply With Quote