MobileRead Forums - View Single Post - Requesting help running calibre-debug on MacOS

bace651 · 10-09-2023, 08:34 PM

Hi all,

I've been trying to follow jhowell's instructions regarding CLI conversion of KPF to KFX:

https://www.mobileread.com/forums/sh...4&postcount=45

I am using MacOS and running into the following error message:

zsh: command not found: calibre-debug

I've been troubleshooting this for hours now, looking up other posts about this issue, but I am not too tech-savvy and am having trouble following how to resolve this. I've tried running this command by opening a terminal where the .KPF file is, and also tried running this command by clicking calibre-debug under Applications. I'm at my wit's end, feeling like I'm missing something as I am new to command lines in general... I would greatly appreciate some advice.

10-09-2023, 08:34 PM	#1
bace651 Junior Member Posts: 9 Karma: 10 Join Date: Oct 2023 Device: Scribe	Requesting help running calibre-debug on MacOS Hi all, I've been trying to follow jhowell's instructions regarding CLI conversion of KPF to KFX: https://www.mobileread.com/forums/sh...4&postcount=45 I am using MacOS and running into the following error message: zsh: command not found: calibre-debug I've been troubleshooting this for hours now, looking up other posts about this issue, but I am not too tech-savvy and am having trouble following how to resolve this. I've tried running this command by opening a terminal where the .KPF file is, and also tried running this command by clicking calibre-debug under Applications. I'm at my wit's end, feeling like I'm missing something as I am new to command lines in general... I would greatly appreciate some advice.