Quote:
Originally Posted by Renate
Do you have the device RX and your USB UART TX connected?
Reboot and then in Putty hold the "Backspace" key down solid.
It should go directly to recovery without rebooting again.
|
Thanks so much for taking the time to try and help me, much appreciated.
I did GND from UART to GND (square terminal on Note2), and TX from my UART to one of the remaining two terminals on the Note2 next to the square one.
I did this for each of the terminals and attempted a complete cycle. No change.
I would power off, connect GND and TX from UART, power button on, when I see blue light, I then press backspace. I would wait a while (15-20secs) holding backspace, the blue light just cycled and it rebooted. I did the same sequence with the other terminal on the Note2 as well.
I also tried to remap Backspace to Ctrl+h in Putty and tried that sequence as well.
The TX light on my UART goes solid when I press the backspace key (or the ctrl+h key combo) so it recognizes that I'm sending something I reckon.
For completeness, I went through all the above with Putty on a Windows laptop (my default is a Linux laptop). Same results.