Quote:
Originally Posted by davidfor
If the automatic store is being done and showing books with updated status, then pressing the OK button should update all the books shown in the list. The books will have a check against them. If the books are being unchecked somehow, then they will not be updated.
The only thing I can think of is if the automatic store is using a profile that is different to the one used by the manual store. The profiles set which columns to use for each value stored. If automatic store isn't storing the values that are used in the checks, then the next check will not see any difference.
Other than that, nothing comes to mind. If checking the configuration doesn't show anything, run calibre in debug mode, connect the device and do the stores, then close calibre and post the full debug log. Hopefully I will be able see the problem from that.
|
Logfile is attached. There's 2 runs there. The first "completes" two books and updates the position of a third. The second run is straight after a disconnect/reconnect of my Forma. The two books that were completed on the first run come up again. All relevant checkboxes to store changes are checked. Sorry it took so long to post my response.