[kobo-a-one]

Originally Posted by baskerville

It might be worth checking that the Went to sleep …, Woke up … messages in info.log match your description.

You might be actually right, after checking the log:

event: Went to sleep on March 28, 2022 at 16:20. - closed the sleep cover after finishing the reading and the battery was at ca 95%

event: Woke up on March 28, 2022 at 16:46. Probably because of some movement in the bag where the kobo was, the system went online again. I haven't used the ereader during this time, neither powered it on manually.

event: Went to sleep on March 29, 2022 at 07:30. after checking the KA1 in the morning - battery was at 0% and I powered it off via the button at the back of the device.

Went to sleep on March 28, 2022 at 13:02.
Woke up on March 28, 2022 at 15:15.
Went to sleep on March 28, 2022 at 15:48.
Woke up on March 28, 2022 at 15:59.
Went to sleep on March 28, 2022 at 16:20.
Woke up on March 28, 2022 at 16:46.
Went to sleep on March 29, 2022 at 07:30.
Woke up on March 29, 2022 at 07:30.
Went to sleep on March 29, 2022 at 07:32.
Woke up on March 29, 2022 at 07:43.
Went to sleep on March 29, 2022 at 07:44.
Woke up on March 29, 2022 at 07:44.

I suspect the sleep cover is the culprit:
a) either it's powered on due to involuntary movements while being inside the bag;
b) or there is another process that wakes the reader up; (needs investigation)

would it be possible to control the behavior of the sleep cover from the Plato itself? say be able to enable/disable it? also perhaps power off automatically if the system is on for N minutes and there is no "activity"?

I will try to disable the Sleep Cover completely in Nickel and test again.

Originally Posted by baskerville

Those are the load averages for the last one, five and fifteen minutes.

Thank you, this makes sense now. Perhaps it would be more informative if we could add a bit more info about the timeframes in the description field, something like "1M | 5M | 15M"

Originally Posted by baskerville

You can access the underlying Linux layer via Telnet or SSH.

Could you point me to the right manual how to do that? AFAIK there is no sshd daemon running by default and it will require some installation.


Another quick question if I may

Is there a way to customize the keyboard layout? I can't get used to the "backspace" being on the left rather than in its usual position on the right? I tried to modify json file with the layout swapping the positions but it causes the plato to crash whenever the keyboard is called.

Thank you for your help.