[KevinH]

@odamizu,

I can not see any code "bugs" in SavedSearch given the rules of my previous post but I can see there is a "use-ability" bug based on your post.

So I used a suggestion you provided earlier and made the Saved Search "Load Search" button now do the following:

- rebuild the set of searches to run as if you had selected something else and then reselected what you had originally (a SavedSearch Group or single search)

- then had it tell F&R to do a Restart

By adding those two things, then when you use LoadSearch, it will be telling it to also begin the entire current selection of searches from the top again.

The issue is Count All in Saved Searches. It will always count all existing matches for whatever is remaining of the Search Group searches to be run from that point *onward*.

To see where you are when running a SavedSearch Group, look at the status message in the lower left hand corner of Saved Search. It should always tell you which search is now active and when you have run out of searches.

Hope this is an improvement. I will make a new test build (no other F&R changes) later tonight in case others report bugs today that I can track down and fix in time.

Once I have posted it, please give that new build a test run in SavedSearches given your understanding from above and see if the "use-ability" is improved.

If you wanted CountAll to work from the beginning of a SavedSearch Group, you can now use LoadSearch to make that happen.