View Single Post
Old 01-15-2022, 11:59 AM   #5
eddie.t.h
Addict
eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.eddie.t.h is an accomplished Snipe hunter.
 
eddie.t.h's Avatar
 
Posts: 201
Karma: 123456
Join Date: Jan 2018
Device: Too Much Kindle :-)
The battery error is caused by one of the connector pins being out of contact from the thermistor built into the battery. So I would look for anything that this lack of connection could be causing. Of course, it is possible that the damage is inside the battery.
What voltage do you have the ttl converter for? Check that you have a good ground connection.
The board will not boot up without the display plugged in.

Last edited by eddie.t.h; 01-15-2022 at 01:14 PM.
eddie.t.h is offline   Reply With Quote