Quote:
Originally Posted by eddie.t.h
Uboot does not boot properly so afaik you can't do anything programmatically. It looks like there is no communication with RAM. In this model RAM is in one chip with flash memory.
|
"Reset cause: POR" Sounds like a generic hardware reset.
"FSL_SDHC" - lines refer to emmc / other memory, right?
It does respond to serial terminal, so I'd assume RAM works...
If not by programming, what would be the options?
As for removing the screen sounds to me not difficult, but rather next to impossible as it's embedded onto the pcb. Since all active components are on the backside, would be the exact purpose?
I have a hot air station and I was doing okay pretty much everything other than BGA...