Thread: Firmware 4.28.18220
View Single Post
Old 09-30-2021, 11:39 PM   #174
Deobulakenyo
Guru
Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.Deobulakenyo ought to be getting tired of karma fortunes by now.
 
Posts: 706
Karma: 2153490
Join Date: Aug 2021
Location: Stupid Philippines
Device: Kobo Libra 2, Boyue Likebook P78
Quote:
Originally Posted by DNSB View Post
I would try just installing the older firmware first. If you have issues, then time for the factory reset.
  1. Kobopatching is not quite the same as NickelMenu but the installation is much the same.
  2. You can use NickelMenu on a patched Kobo. I have not read of any issues with doing so.
  3. You select the patches you want and change the no to yes to enable the patch.
  4. See the above for running a few patches. I use 3 or 4 out of the full patch set.
Thank you very much, but i have to ask, where is this "above" post that I can refer to?

and i hate to be e total noob but i am. I downloaded the patch and unzip it trying to look at the files and understand them. is there some sort of a config file where the individual patches can be turned on or off?
Last edited by Deobulakenyo; 09-30-2021 at 11:43 PM.
Deobulakenyo is offline   Reply With Quote