Quote:
Originally Posted by MGlitch
On firmware 4.28.17925 the invert option in NM does not seem to work.
NM v0.5.2
config
#invert
menu_item:reader:Invert Screen:nickel_setting:toggle:invert
screen flashes briefly, then remains inverted.
I don't mind terribly because I prefer to read in inverted mode, but figured I'd see if there was a solution. I have patched my Forma, but the replace adobe page numbers w/ invert is not enabled. I can't think of anything that I would have done that would interfere with this, especially since I had to do a hardware factory reset (so everything was zapped) recently.
|
Quote:
Originally Posted by geek1011
I have a WIP version here which can control DarkMode. I still need to figure out how to make it apply without reopening the reader.
I will look into InvertScreen later. |
Quote:
Originally Posted by geek1011
If you have a GitHub account, you can access the artifacts list in the build (click the green checkmark). Otherwise, I've attached it here.
|
there are also mentions of this in the thread for 4.28 firmware just released for all Kobo devices.