MobileRead Forums - View Single Post - Onyx Boox Kon-Tiki 2 (Nova3 platform)

Renate · 08-11-2021, 06:35 AM

Did you do that one with the big log from a fresh reboot?
It looks to me like your drivers are good but the sahara protocol was already stalled.
(I've got it easier because I have my reed switch and I can just hit power for 1 second and I'm back in fresh EDL immediately.
You have to do a reset, wait for it to boot to Onyx, then adb reboot edl.)

The first time it should say:

Code:

main - Device detected :)
main - Mode detected: sahara

After you load the loader it will say:

Code:

main - Device detected :)
main - Mode detected: firehose

You only need to load the loader once for every reboot.
In upgrading the protocol from sahara to firehose there should be no USB glitch or disconnect.

You might use my UsbLog.exe (in the sig).
It's handy for seeing USB connect/disconnects.

If you're still having problems I can send you a little test.

08-11-2021, 06:35 AM	#23
Renate Onyx-maniac Posts: 4,004 Karma: 18026955 Join Date: Feb 2012 Device: Nook NST, Glow2, 3, 4, '21, Kobo Aura2, Poke3, Poke5, Go6	Did you do that one with the big log from a fresh reboot? It looks to me like your drivers are good but the sahara protocol was already stalled. (I've got it easier because I have my reed switch and I can just hit power for 1 second and I'm back in fresh EDL immediately. You have to do a reset, wait for it to boot to Onyx, then adb reboot edl.) The first time it should say: Code: main - Device detected :) main - Mode detected: sahara After you load the loader it will say: Code: main - Device detected :) main - Mode detected: firehose You only need to load the loader once for every reboot. In upgrading the protocol from sahara to firehose there should be no USB glitch or disconnect. You might use my UsbLog.exe (in the sig). It's handy for seeing USB connect/disconnects. If you're still having problems I can send you a little test.