MobileRead Forums - View Single Post - Poke 3 (& Poke 2, other Onyx?) screen light

kndlewis · 07-03-2021, 02:21 PM

I apologize for any misunderstanding. I have a Poke2 that has become my favorite reader. I also have an original Poke. The original Poke has both white and red LEDs but has only one slider for the light control. When the slide is centered, the light is effectively off. Sliding to the right activates the red lights and sliding to the left activates the white light. There is no mixing possible with this set up.
The Poke2 is fine. I suspect very similar to your Poke3 as far as the software. Poke2 = android 9, Poke3 = android 10 and micro usb vs. usb C. The lights should be the same.
I was trying to get some lighting mixture introduced into my original Poke. That's the one where 5% on your app is quite bright.
I wish I could help out with some of the setting commands you mention.

07-03-2021, 02:21 PM	#14
kndlewis Connoisseur Posts: 83 Karma: 10510 Join Date: Nov 2010 Location: Ohio, USA Device: Current Favorite: Boox Leaf	I apologize for any misunderstanding. I have a Poke2 that has become my favorite reader. I also have an original Poke. The original Poke has both white and red LEDs but has only one slider for the light control. When the slide is centered, the light is effectively off. Sliding to the right activates the red lights and sliding to the left activates the white light. There is no mixing possible with this set up. The Poke2 is fine. I suspect very similar to your Poke3 as far as the software. Poke2 = android 9, Poke3 = android 10 and micro usb vs. usb C. The lights should be the same. I was trying to get some lighting mixture introduced into my original Poke. That's the one where 5% on your app is quite bright. I wish I could help out with some of the setting commands you mention.