|
Hey all,
I'm having a little trouble after soldering the serial port wires. Followed the guide to a T, managed to get the wires on the appropriate solder pads (only RX and TX, decided to use a screw hole for ground, and didn't hook up the 1.8V one, as I would be running from battery). Serial port works fine, managed to get into diag mode, removed the password requirements for the `root` user from the main OS partition. Diag mode also works fine.
However, if I boot the PW3 in regular mode... After loading, the device is stuck on the screensaver, and does not react to the power button at all. Serial port access works, and I managed to log in as root, however after some time, the serial port stops accepting any input (TXD does not even blink on my adapter). Receiving still works, as e.g. if I force a reboot by pressing the power button for 15 seconds, I can see the logs being output.
Because of this, I can't even run the jailbreak script, as it freezes out before I even get there.
Is there any solution? I've been thinking about grabbing an older firmware and forcing an update from the recovery menu.
|