Thread: Aura ONE Can't get past language selection
View Single Post
Old 02-13-2021, 01:44 AM   #8
davidfor
Grand Sorcerer
davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.davidfor ought to be getting tired of karma fortunes by now.
 
Posts: 24,905
Karma: 47303824
Join Date: Jul 2011
Location: Sydney, Australia
Device: Kobo:Touch,Glo, AuraH2O, GloHD,AuraONE, ClaraHD, Libra H2O; tolinoepos
Quote:
Originally Posted by manisharma View Post
No I can't touch any language it. Just turns on and there is that.
It has been a while since I did a setup on an Aura ONE, so I'm not sure exactly what it looks like. If it is just a list of languages, then it sounds like the touch isn't working at all.
Quote:
Any link or way to flash the device as it is ? Computer can't detect the device though.
There isn't any way to flash a new image to the Aura ONE

From what you have said, I would try:
  • Powering off the device and plugging it in to the PC before turning it on. It's possible the device will autoconnect when powered on and in setup mode. Some firmware versions/devices will, I'm just not sure about this one.
  • A factory reset. You mention doing this and the device working, then doing something else and breaking it. I would suggest starting again with the factory reset. If the touch isn't working after that, then you probably need to open the device ad check the cables. Or replace it.
davidfor is offline   Reply With Quote