Hello, fellow posters. This is my very first post (though I have been reading the boards for some time), and I need some help.
I purchased a skin from DecalGirl and, while the skin itself is great, I had a hard time getting it right. I started in the front, lining up the screen and side buttons perfectly, but by the time I got it around the back, there was a small gap of about 1/8 of an inch along the outside edge where the two ends didn't meet. The edges of the skin wouldn't lay flat, and it just really bugged me (I'll be the first to admit I'm a little obsessive about the details!).
I peeled it off and started again, stretching it a bit, but now it's stretched out by the screen, bubbled in the back. and just barely overlaps on the outside edge.
I'm thinking about getting a new one. If I do, does anyone have any tips to get it right? Is it possible my skin was a little too small?
Thank you to anyone who can help a newby out!
