Thread: M5Paper e-ink device for DIY
View Single Post
Old 01-30-2021, 07:48 PM   #26
Adoby
Handy Elephant
Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.Adoby ought to be getting tired of karma fortunes by now.
 
Adoby's Avatar
 
Posts: 1,737
Karma: 26785684
Join Date: Dec 2009
Location: Southern Sweden, far out in the quiet woods
Device: Samsung Galaxy Tab S8 Ultra
Quote:
Originally Posted by hobnail View Post
Which board do you recommend?
My favorite is the Wemos esp32 d1 mini board. There are a lot of "shields" for various purposes that plugin and are easy to use. Sensors, relays, displays and more. And it is cheap. But perhaps a bit old now...

Also check out the devices offered by M5stack. More polished and less need for soldering.

All can be used with C/C++ or MicroPython. You can start small and cheap to see if you can figure it out.

(I don't recommend the board you linked to. It has a long range low bandwidth radio transmitter and is intended for communication purposes. Sensor networks, for instance.)
Last edited by Adoby; 01-30-2021 at 08:12 PM.
Adoby is offline   Reply With Quote