Quote:
Originally Posted by ottischwenk
This isnt possible.
|
I guess its possible That is what was displayed under properties....
When I connect my Alita to the PC I get one icon with the Reader. I open that and I see two icons. One for SD card and one for internal drive. And when I click properties both say Format: Generic Hierarchical.
Quote:
Originally Posted by ottischwenk
Then I'm afraid it is defective.
|
I then proceeded and put my SD card out of Alita and into my SD card reader. Now it says FORMAT: exFAT and the opening of my folders was a lot faster. With card in Alita it took a while to load all folders.
Also the most important thing there was absolutely NO PROBLEM with copying files (even 1GB+).
So this is pure Alita fault not the SD card. But I don't really know what's causing this. Software bug? Random write failure of SD slot? I think file size is not a problem either since sometimes it adds 5 files which are all about the same size and fails with the sixth. Copy window closes before ending and I see 5 files instead of 6. It's kinda random. Aside from that it doesn't want to copy failed file anymore via Alita if I try again the copy status bar just go to the previous location and hangs there for a bit then closes.
And again everything works normal on SD card reader as I said.
Code:
The type of the file system is exFAT.
Volume Serial Number is 0000-0000
Windows is verifying files and folders...
File and folder verification is complete.
Windows has scanned the file system and found no problems.
No further action is required.
125009920 KB total disk space.
94255360 KB in 582 files.
17280 KB in 135 indexes.
0 KB in bad sectors.
256 KB in use by the system.
30737024 KB available on disk.
131072 bytes in each allocation unit.
976640 total allocation units on disk.
240133 allocation units available on disk.