Hello everyone, first of all thank you very much for all the information and availability you have in this forum.
I have the following problem, a K5 does not start, but the battery if it is charged, try to recover it with Kubrik, but it is frozen in usb donwload mode.
Then I tried MfgTool, which leaves it in fastboot. But after that he is paralyzed again.
Finally I used the USB TTY cable, and I have the following dialog:
Spoiler:
U-Boot 2009.08-lab126 (Apr 04 2012 - 20:06:50)
CPU: Freescale i.MX50 family 1.1V at 800 MHz
mx50 pll1: 800MHz
mx50 pll2: 400MHz
mx50 pll3: 216MHz
ipg clock : 50000000Hz
ipg per clock : 50000000Hz
uart clock : 24000000Hz
ahb clock : 100000000Hz
axi_a clock : 400000000Hz
axi_b clock : 200000000Hz
weim_clock : 100000000Hz
ddr clock : 800000000Hz
esdhc1 clock : 80000000Hz
esdhc2 clock : 80000000Hz
esdhc3 clock : 80000000Hz
esdhc4 clock : 80000000Hz
MMC: FSL_ESDHC: 0, FSL_ESDHC: 1
Board: Whitney WFO
Boot Reason: [POR]
Boot Device: MMC
Board Id: 0061401114870BWE
S/N: B011140714
DRAM: 256 MB
Using default environment
In: serial
Out: logbuff
Err: logbuff
Quick Memory Test 0x70000000, 0xfffe000
POST done in 13 ms
Hit any key to stop autoboot: 0
## Booting kernel from Legacy Image at 70800000 ...
Image Name: Linux-2.6.31-rt11-lab126
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 5197856 Bytes = 5 MB
Load Address: 70008000
Entry Point: 70008000
Verifying Checksum ... Bad Data CRC
ERROR: can't get kernel image!
If i try
bootm 0xE41000
appears
THK a lot