MobileRead Forums - View Single Post

drawson1 · 05-03-2020, 06:52 AM

I have a new Clara with KSM9 installed. KSM/KOreader/Coolreader are all working great, THANKS!

I had ONE problem - if I tried to start USB with "usb enable id like nickel.sh", it would always fail with "/mnt/onboard is busy". If I started and stopped nickel, it would work.

I discovered that if I set "useDropbear=false" in the config file, I do NOT get this error. lsof does show a couple of the Dropbear files open immediately after a reboot.

Is this a known issue? Or is there some other config modification that is needed? I found some discussion on the thread from a couple of years ago, but it looked like it was before the release of KSM9

Thanks!

Dan

05-03-2020, 06:52 AM	#726
drawson1 Connoisseur Posts: 96 Karma: 10 Join Date: Mar 2014 Device: Libra H20, Clara 2E	/mn/onboard is busy I have a new Clara with KSM9 installed. KSM/KOreader/Coolreader are all working great, THANKS! I had ONE problem - if I tried to start USB with "usb enable id like nickel.sh", it would always fail with "/mnt/onboard is busy". If I started and stopped nickel, it would work. I discovered that if I set "useDropbear=false" in the config file, I do NOT get this error. lsof does show a couple of the Dropbear files open immediately after a reboot. Is this a known issue? Or is there some other config modification that is needed? I found some discussion on the thread from a couple of years ago, but it looked like it was before the release of KSM9 Thanks! Dan