JB Report
-------------------------------------
PW3/Manga/32GB.
FW: 5.10.1.1
SO status: Removed by Amazzzzoonn.
JB status: Successfully.
-------------------------------------
Just want to share my experience.
Tear-down. This is the first time I do it.
A little closer to the mainboard.
Wiring. I used a PL2303 calble from eBay.
https://www.ebay.com/itm/142006114032
If you pick this cable, please use this driver:
http://www.prolific.com.tw/UserFiles...ller_v1200.zip
Only need Tx, Rx, GnD. The red one is 5V output. We should not touch it.
Solder works is difficult to me. My eyes good but my hand shaking to much.
We should suggest AMZ to improve their serial point, bigger maybe.
Serial mode is now woking. And this is the part make me confused.
When I do "bootm 0xE41000", the last line look like that:
Quote:
system: I mntroot:def:Making root filesystem writeable
[ 11.946228] EXT3-fs (mmcblk0p2): using internal journal
sock_init 1888
|
Tried fews things and did not help.
Look at the screen.
OK, let me show you how the Touch-screen look.
At this step, we will have two choices.
01/ Use touch screen
=> (o)-Reboot or Disable Diagg
=> Login screen
Then you can login with root/fiona_something.
And option 2:
Google : sock_init 1888 kindle
I found this one.
https://www.mobileread.com/forums/sh...9&postcount=22
From the post of stupidhaiku, just input "exit login"
Then you can login with root/fiona_something.
Next step should be processed exactly as the #1 of this thread.
Sending file via USB mode. USB mode can be enabled via Diag mode by toching the screen.
Any next step could be done with no error.
MRPI and KUAL should be installed just after do jb.sh thing.
And after finished JB, I don't want to do the solder works again. So just keep it inside and close the plastic cover.
Play with Screensaver hack.
--------------------------------------------
Thank you for every post here in this forum give me a chance to finish this JB.
Please ask me if you need more pics, info or something else I could support.
