Quote:
Originally Posted by hius07
One more try. PW3 updated to 5.12.2, installed hotfix, installed KUAL (coplate).
Trying to run KUAL caused error some of "Application cannot be started. Try again later".
Logs attached.
|
That log file has an awful lot of error and warning messages.
About the same as the last ten years.
Lab126 again ships a firmware that is f...ing lucky to even boot.
Things might improve a little bit if they got their compiler setup to match the machine's instruction set (now that is not up to "professional" standards of any kind).
-- -- -- -- --
That all reads as if it was a start or re-start of the 5.12.2 and the logs produced during the previous run (the installation of the new firmware by the previous firmware) have been "lost" in the bit bucket.
Hmm ...
Well it does report some of the kernel's print buffer from the prior execution, but not enough to be interesting.
I should have written above that the "interesting logs" have been lost in the bit bucket.