Quote:
Originally Posted by xtine
Where are the IR LED's? I was actually wondering about that since I've already taken the whole thing apart yet haven't seen/recognized them at all. The touch part just seems to work like magic when I slap the front bezel back on 
As for the white tape, that's actually just covering the other sticky side of the double-sided tape which I removed when I stuck the front bezel back on. Thanks for the reminder about disabling the "water droplets detection" though, I'd forgotten about that 
The front bezel actually is still sticking up around the corners despite the double-sided tape. I'm wondering if super glue would be a better solution although I'm a bit wary of such a "permanent" solution in case I need to open it up again. |
Hahahah, if in doubt , SUPERGLUE.
Dont do that, you might need to open it again, or decide to waterproof it, you never know.
I wouldnt have even put new tape, had mine opened and closed probably for more than 20 times, and even scraped with a fingernail most of the glue residue so there are no bumps, and it still holds. Its in a case though, which probably also helps with holding the bezel in place as the case has tiny notches just above it.
The ir leds are those gray pimples on the sides.