Quote:
Originally Posted by ameinias
Ran into another issue..
Exit, switch and power off all work in nickel, but toggle night mode doesn't. (Might be because I tried updating the icons to a nice pack I found on here, although they don't seem to have updated - I don't remember if I tested it before.) I can toggle the night mode in a config file deep in KSM, but I'd like to be able to use that icon right in nickel.
|
Are you talking about the nightmode for nickel? If yes, which nightmode? Do you toggle it with "edit nightmode conf.sh" (then you are using the external nightmode for nickel)? Or do you toggle it with "edit nickel conf.sh (InvertScreen=true)" the you are using the internal nightmode of nickel? If it is the first case the problem is likely with the toggle_nightmode icon. Try deleting it from within nickel, and then copy it again to the device. After opening the icon in nickel, exiting and reentering nickel it should start working.
If you are using the internal nickel nightmode, you cannot toggle it from within nickel. If the internal nightmode works on other devices as well as on my Touch with FW 4.12.12111, I am rather sure nobody does use it. I only found out now, since I usually do not use nightmode.
Quote:
Originally Posted by ameinias
I'm also getting that /mnt/onboard is busy message maybe 2/3 restarts when I try to enable USB. Pretty sure it started happening after I installed ksm_nightmode.
|
I cannot see how this could be related to the ksm_nightmode. You might find out with the ps command via the webinterface which file is running from the user partition.
Quote:
Originally Posted by ameinias
Is there anyway to enable USB in nickel again? Turns out I really like Nickle as a reader, but it won't recognize my books unless it can see there's been a USB connection.
|
How did USB stop working in nickel? Nickel is my preferred reader for epubs to on Kobo.