Thread: Tutorial Brand new PaperWhite 4 (2018) factory image JailBreaking
View Single Post
Old 01-30-2019, 04:12 AM   #331
knc1
Going Viral
knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.knc1 ought to be getting tired of karma fortunes by now.
 
knc1's Avatar
 
Posts: 17,212
Karma: 18210809
Join Date: Feb 2012
Location: Central Texas
Device: No K1, PW2, KV, KOA
Quote:
After a successful factory image jailbreak of 5.10.0.2 I have yet to update to a newer version. However, I found my battery life poor.
(No shit)

You must, repeat MUST, install a consumer-use firmware build, even if it is the same firmware version.

Nothing here is intended to be run on a factory-use firmware build, other than the jail break vector.

In fact, the only thing which is intended to run on a factory-use firmware build are the Q.A. routines it includes.
That is, do not be so surprised that it does not run as expected for a consumer-use firmware, since it is NOT a consumer-use firmware.

Eliminate the PEBKAC from your observations and report back on any changes from what you have observed above.
Last edited by knc1; 01-30-2019 at 04:16 AM.
knc1 is offline   Reply With Quote