Hello,
My equipments :
- OTG cable
- powered USB hub that use only has a power source
- USB hub (my monitor with 2 USB connectors)
- USB key voltmeter/ammeter
- USB cable
- USB Keyboard
- USB drive key
The USB cable make a link between to the OTG's input and the USB hub (monitor). On the monitor the USB keyboard and the USB drive key are connected. The second part of the OTG cable is connected to the powered USB hub.
When the keyboard is detected, it is possible to configure his layout.
The keyboard is recognized in NeoReader2 but not in the application Note.
In A2 mode, the speed of refresh is adequate.
The keyboard and the USB drive key can be used together
