Thread: PRS-T1 bootloop
View Single Post
Old 11-19-2018, 01:38 AM   #4
charmees
Junior Member
charmees began at the beginning.
 
Posts: 4
Karma: 10
Join Date: Nov 2018
Device: PRS-T1
Thank you for responses.

Quote:
Originally Posted by Barbara1955 View Post
Turn it Off Wait a few Mins..... then turn back on.
It can not be turned off I think, pressing/holding reset, nor turn off does nothing unfortunately. The openining book window is always on and the reader is blinking orange light.

Quote:
Originally Posted by DoctorM View Post
If Barbara1955's suggestion doesn't work, you could try Porkupan's SD rescue package.
This can be complicated, check out this post: https://www.mobileread.com/forums/sh...72&postcount=5

There are 2 steps on the guide.
  1. Press and hold HOME and MENU before pressing POWER on the Reader and keep HOME and MENU pressed (this is crucial!)
  2. Wait until the progress bar in the “Opening book" page has reached the right side (about 20 seconds). The message will change to “Updating”. Release buttons. From now on there should be no more visible activity except for the constant blinking of the orange light (within the power button).


Question
  1. I did and it and hold the buttons, good news is that this is the first time over long time I see something moving on the screen, the Opening book progress bar moved from 0 to 100. Problem is that, I hold the buttons for couple of minutes, but progress was 100%, but the updating message did not appear. Any suggestions?

EDIT:
After 15 minutes I see that the progress bar has moved back to 0, maybe it restarted itself, but still stuck at 0 now. Checked the sd card, the diag.log did not also appear

Last edited by charmees; 11-19-2018 at 03:19 AM.
charmees is offline   Reply With Quote