I wasn't sure where to put this so if I'm in the wrong forum, mea culpa and move it.
I just updated to 3.3.1 and I've run into a problem I've never had before. For the first time I end up in the wizard and after chosing library location and generic e-ink device (also tried Kobo since I have a Aura One I click on the Finish button and nothing happens, Calibre won't launch. Should add that I tried a new empty folder if the problem was my library. I deleted and downgraded to 3.20 just to see what happens. But now I run into the wizard in 3.20 and there is the same problem, eg I click finish after it finished installing and it won't launch as in, nothing happens. I tried rebooting, turning off Norton etc. Very strange problem.
Is there any way I can bypass the wizard like I could do previously? I should add that I installed the portable version and it works fine.
