Quote:
Originally Posted by OoMG
Hi, my PW3 wasn't able to start.
I tried to rescue it by using TTL, but it can't boot into recovery menu.
it shows "can't get kernel image".
Is there anyone could help me?
Thanks very much.
Code:
U-Boot 2009.08-lab126 (Nov 29 2017 - 11:20:27)
CPU: Freescale i.MX6 family TO0.0 at 996 MHz
Temperature: 42 C, calibration data 0x55a4e15f
mx6sl pll1: 996MHz
mx6sl pll2: 528MHz
mx6sl pll3: 480MHz
mx6sl pll8: 50MHz
ipg clock : 66000000Hz
ipg per clock : 66000000Hz
uart clock : 80000000Hz
cspi clock : 60000000Hz
ahb clock : 132000000Hz
axi clock : 198000000Hz
emi_slow clock: 22000000Hz
ddr clock : 396000000Hz
usdhc1 clock : 198000000Hz
usdhc2 clock : 198000000Hz
usdhc3 clock : 198000000Hz
usdhc4 clock : 198000000Hz
MMC: FSL_ESDHC: 0,FSL_ESDHC: 1,FSL_ESDHC: 2
Board: Muscat WFO
Boot Reason: [ POR ]
Boot Device: NAND
Board Id: 0670201152540N3B
S/N: G090G********
I2C: ready
DRAM: 512 MB
Using default environment
In: serial
Out: serial
Err: serial
Quick Memory Test 0x80000000, 0x1fff0000
POST done in 111 ms
BOOTMODE OVERRIDE: DIAGS
Battery voltage: 3857 mV
Hit any key to stop autoboot: 0
Wrong Image Format for bootm command
ERROR: can't get kernel image!
uboot >
|
Code:
BOOTMODE OVERRIDE: DIAGS
ERROR: can't get kernel image!
Do what it is telling you it requires, install a "diags" system kernel image.
PS: do not wait until you see:
Code:
Hit any key to stop autoboot: 0
Instead, as soon as you see output on the serial port line, press AND HOLD the "any key" down until u-boot sees it.
