Quote:
Originally Posted by JIPG-reader
Hello GeoffR.
First of all, thank you very much for your patches. They improve very much the reading experience 
I have a doubt about the line space patches. At the beginning you had the patch `My 15 line spacing values`, but now there are two, with 10 or 24 values.
I would like to use the original number of values, but changing them, so abusing of your kindness, I would like to ask you about any hints you can provide to do it.
Edit: I have found some clues from you in post https://www.mobileread.com/forums/sh...8&postcount=62.
I should use the 24 values line spacing patch and change a 0 by a seven (marked in red below):
# Replacement value: the number of initial line spacing values to exclude from
# the line spacing slider; minimum 0, maximum 13. E.g. 9 will result in a
# slider with 15 positions, starting from the 10th replace_float value below.
replace_int = 659D66, 0, 7
Is it correct? |
Would you mind sharing, which options increase your reading experience? I went through the 4 .patch files, but I'm not sure where to begin.