|
Good news and bad news. Tested the functionality of being able to successfully switch usbnet off while plugged in, and that part is behaving as in r15022 (which is to say that usbms works after the toggle off and usbnet still works after toggling on again).
Unfortunately, when testing to see if your abort failsafe worked when unplugged, it crapped out. This was on the same... not sure what to call it... same boot(?) as when I'd switched it on and off and on already -- so I'll give it one more try on a fresh go.
But it's the same behavior as most of the rest of it: hit the toggle in kual and the readout at the bottom immediately garbles and the whole thing freezes and eventually reboots itself
|