Quote:
Originally Posted by 1616jlg
Hi All
I followed DNSB's suggestions and Calibre will now load. The only problem, I can't work out what resolved the issue as I have now turned back on all services I disabled and the issue doesn't present again. I also booted with low resolution but have rebooted into normal mode again (still can't replicate my previous issue).
So... thanks everyone and apologies for not being able to point to exactly what was wrong. If the issue comes back, I'll perform the same troubleshooting steps and provide more detail with exactly what caused the issue.
|
Congratulations on getting this going. I felt bad I couldn't help but I've been using Linux for about ten years now and have to dragged in to work on my wife's Windows computer any more (and I'm about worthless when I do "help" her). With Linux, if there was an error starting Calibre, I would just type 'calibre' in a terminal and it would return the error, so at least I would know where to start.
At any rate, all's well that ends well. I'm glad you got it working.