Thread: Question on setting up calibre-server on Pi3 running Arch Linux ARM
View Single Post
Old 12-17-2017, 03:06 PM   #12
haertig
Wizard
haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.haertig ought to be getting tired of karma fortunes by now.
 
Posts: 1,899
Karma: 31522252
Join Date: Sep 2017
Device: PW3, Fire HD8 Gen7, Moto G7, Sansa Clip v2, Ruizu X26
Can calibre-server run as a "socket activated" service under systemd? So that it is not running continuously, but only gets started when an incoming connection attempt is made, and then exits after servicing that connection?
Last edited by haertig; 12-17-2017 at 03:08 PM.
haertig is offline   Reply With Quote