Hi all,
I've managed to make a bit of a mess of my KT2. I managed to install the wrong image when jailbreaking and now the Kindle refuses to boot, and I am not able to connect to it through USB. Cracked it open and attached a serial adapter to receive the following output:
Quote:
U-Boot 2009.08-lab126 (Aug 07 2014 - 00:52:13)
CPU: Freescale i.MX6 family TO0.0 at 996 MHz
Temperature: 29 C, calibration data 0x58250a5f
mx6sl pll1: 996MHz
mx6sl pll2: 528MHz
mx6sl pll3: 480MHz
mx6sl pll8: 50MHz
ipg clock : 66000000Hz
ipg per clock : 66000000Hz
uart clock : 80000000Hz
cspi clock : 60000000Hz
ahb clock : 132000000Hz
axi clock : 198000000Hz
emi_slow clock: 22000000Hz
ddr clock : 396000000Hz
usdhc1 clock : 198000000Hz
usdhc2 clock : 198000000Hz
usdhc3 clock : 198000000Hz
usdhc4 clock : 198000000Hz
MMC: FSL_ESDHC: 0,FSL_ESDHC: 1,FSL_ESDHC: 2
Board: Unknown
Boot Reason: [ POR ]
Boot Device: NAND
Board Id: <redacted board id>
S/N: <redacted serial number>
I2C: ready
Invalid board id! Can't determine system type for RAM init.. bailing!
DRAM: 0 kB
Using default environment
In: serial
Out: serial
Err: serial
Quick Memory Test 0x80000000, 0xffff0000
POST done in 4 ms
|
Unfortunately I am not able to do anything at this point - no input into the putty terminal will bring up a console, I've tried hitting enter multiple times on boot, but I guess it hasn't got to the autoboot boot step to be able to cancel it.
I understand fastboot will help me here, however I don't know how I can get to fastboot - I am not able to bring up the uboot console, and I cannot enter USB Debugging mode from the Kindle as it is not recognised by the PC (I hear Window's connect tone, followed immediately by the disconnect).
Is there anything I can do at this point? Any advice definitely welcomed, thank you in advance!