|
Firmware version 5.4.3 is not equal to 5.4.3.2 (the numbers are not the same, nor is the actual code).
You don't need to install the 'dummy' package unless you want the report.
You are now running a firmware built for use in the "Factory Only" - used for their production line testing, you do need to install a "Customer Use" firmware build.
The directions you followed are correct for that device, your jail break will survive the update to a "Customer Use" firmware package.
None of our add-ins where ever intended to run on a "Factory Only" firmware build.
Which is another good reason to do any update now.
That is Step 7 of the procedure which you are now up to.
That does the switch from "Factory Only" build to "Customer USE" build.
Then do Step 8.
That installs the required application launcher and application installer.
People have in the past made a mistake, when I wrote to skip the next two steps (Step 5 and Step 6) they did not return and finish doing Step 7 and Step 8.
That is, they skip the next four steps (5, 6, 7, and 8) which is wrong.
Just finish out the jail break instructions (doing 7 and 8).
|