View Single Post
Old 08-10-2017, 07:31 PM   #219
Aroth
Enthusiast
Aroth began at the beginning.
 
Posts: 32
Karma: 12
Join Date: Aug 2017
Location: Northeast Texas
Device: KV (5.8.10)
Quote:
Originally Posted by coplate View Post
Hey @Aroth, I sent it tuesday, and it shoudl be getting to you soon.

This is a reminder that board comes set to 3.3v.

While I would not recommend you use it in that configuration on your kindle, I will tell you that my kindle has been tolerant of 3.3v. I make no guarantees that you will not burn out the serial port if you leave it set to that.

The instructions on how to change it are here again ( and probably in the first post of this thread, along with the place to get 1.8v power ): http://jim.sh/ftx/#jumper-configuration
Thanks man!

knc1, do you happen to remember off-hand what size wire you used on your PW3 that you permanently installed the chip in?
Aroth is offline   Reply With Quote