Quote:
Originally Posted by deraeler
G works, N doesnt.
...~~~...
Router settings:
N:
- Mixed mode is on
- channel and ch bandwidth are set to auto
- broadcast is on
- AP isolation is ON
G:
- set to G-only
- ch bandwidth is 20Mhz only
- ch is auto
- broadcast is on
I just turned off the AP isolation for N and CC still doesn't connect.
Everything else is either set to auto or N and G settings are the same.
No access restrictions or MAC filtering are in place.
My phone connects to the N network fine.
CC however, cannot connect to Calibre wirelessly using this network.
|
The bottom line is the error is in your Router not with calibre / calibre companion. They don't care what WiFi protocol or band is being used. I have used a few routers over the last 5 years and CC has had no problems.
After you turned off the AP isolation did you reboot your router? This was most likely the source of your issue. If you did reboot then I would leave AP isolation off, power cycle the router and the phone and try again. Do you have a guest mode on your router? Often this feature also isolates wireless devices from the main network.
Logs wouldn't hurt, you can send them via cc by going to
Settings - Other and scrolling to the bottom and selecting
Email a debug log to Multipie. More
info on submitting logs here.