|
Now, post the output of:
printenv
Please try to keep in mind that you have a hardware model that has never been seen by anyone who has written prior posts.
I.E: You can't just presume that things like the memory map is the same on your PW3-32 and on the PW3-4.
That includes the memory locations of things like the 'diag' kernel.
= = = =
Please post the Japanese links to both the *.bin update package and the corresponding source code.
I (or somebody) needs to read the u-boot code for your model before you proceed any further.
We can not just assume that your mini-uboot build will run the same as the PW3-4 mini-uboot build!
- - - -
But if it does - -
You load the desired u-boot binary into RAM -
Execute it -
Then run 'Erase All' -
At the end of the erase the entire eMMC (and it does, just 'like new') that command will write a copy of the currently executing uboot (and the saved device specific data) to the erased eMMC.
Translate this:
DO NOT attempt the above steps until somebody has read the source code specific to your model to confirm that your build will behave the same.
|