Thread: Calibre doesn't always recognize memory card
View Single Post
Old 06-05-2017, 12:58 PM   #5
gbm
Wizard
gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.gbm ought to be getting tired of karma fortunes by now.
 
Posts: 2,194
Karma: 8888888
Join Date: Jun 2010
Device: Kobo Clara HD,Hisence Sero 7 Pro RIP, Nook STR, jetbook lite
Quote:
Originally Posted by JWalkerMR View Post
Hello,

I'm using Calibre 2.85 64bit on Windows 7 64bit and Kobo Aura H2O Firmware 4.4.9344 with a 32GB Micro-SD-Card.

My problem is:
Card is recognized when I first connect Kobo to USB and then start Calibre. But card is not recognized when I first start Calibre and then connect Kobo, while Kobo main memory is still recognized.

Windows Explorer shows card and main memory correct, reading and writing works fine.

I tried to install Kobo Extented Driver and Tools to Callibre, but same problem.

Any ideas how to solve this problem?
Check your mirco sd card, it might need to be reformatted, going bad, have a corrupted file or the wrong class. You should have at least a class 4.

I seem to get this problem with my nook every couple years, so far the solution has been to factory reset the nook and reformat the sd card.

bernie.
gbm is offline   Reply With Quote