Quote:
Originally Posted by knc1
If you have checked everything else, then you most likely are not using the required 1.8volt interface level to the serial port.
Note:
The same serial port is used, in succession:
SoC built-in ROM code ;
U-Boot ;
Linux kernel ;
So there is plenty to be seen.
Unless you have fried the serial port with the wrong voltage or made a wiring error.
Those are the only choices at this point.
|
Oh... I measured the voltage. It's about 5V... So that must be the reason. Now I'm getting a new one.
I hope this will not be too high for those chip...