MobileRead Forums - View Single Post - KPW3-32 debricking

coplate · 06-03-2017, 06:51 PM

You can wire to ground nearly anywhere on the device. I did my ground under the contacts for one of the screws that hold the board onto the screen, those copper circles are ground.

Also if the serial pads on the front of the board are too small to solder to, I ended up soldering to the back of the board ( you will need really thin wire in order to put it back on )

You can see my pictures in the last post of this thread, on mine the serial pads on the back were labeled TM800 and TM801, this matches the 'P800 SERIAL DEBUG' listed on the front of the board.

https://www.mobileread.com/forums/sh...2&postcount=40

06-03-2017, 06:51 PM	#3
coplate Guru Posts: 645 Karma: 1888888 Join Date: Jun 2009 Device: prs-505, Kindle Keyboard 3g, PW3	You can wire to ground nearly anywhere on the device. I did my ground under the contacts for one of the screws that hold the board onto the screen, those copper circles are ground. Also if the serial pads on the front of the board are too small to solder to, I ended up soldering to the back of the board ( you will need really thin wire in order to put it back on ) You can see my pictures in the last post of this thread, on mine the serial pads on the back were labeled TM800 and TM801, this matches the 'P800 SERIAL DEBUG' listed on the front of the board. https://www.mobileread.com/forums/sh...2&postcount=40