MobileRead Forums - View Single Post

MontyJ · 05-17-2017, 05:20 PM

Well, here I am again...

QNAP TS-251 NAS, x64, 8GB Ram

Previously I was running ok with the qpkg version of COPS 1.0.0RC3. This was installed in my ./Web folder.

I wanted to try the latest COPS 1.1.1, so downloaded the zip.

Saved my current working /share/Web/COPS working folder to a backup location, then deleted everything in the COPS folder. Note uppercase COPS is how it installed using the qpkg.

On my main PC, I unzipped the new version and did a SSH connection and copied it into the original COPS folder on the NAS.

Then I copied over the working config_local.php file.

But cannot get anything to run. If I put in http://192.168.x.xxx/COPS/checkconfig.php, I get the old "Internal Server Error Port 80"

I can't get past this. Any ideas?

Thanks!

Monty

05-17-2017, 05:20 PM	#1523
MontyJ Addict Posts: 224 Karma: 10 Join Date: Jul 2012 Device: Kindle	Well, here I am again... QNAP TS-251 NAS, x64, 8GB Ram Previously I was running ok with the qpkg version of COPS 1.0.0RC3. This was installed in my ./Web folder. I wanted to try the latest COPS 1.1.1, so downloaded the zip. Saved my current working /share/Web/COPS working folder to a backup location, then deleted everything in the COPS folder. Note uppercase COPS is how it installed using the qpkg. On my main PC, I unzipped the new version and did a SSH connection and copied it into the original COPS folder on the NAS. Then I copied over the working config_local.php file. But cannot get anything to run. If I put in http://192.168.x.xxx/COPS/checkconfig.php, I get the old "Internal Server Error Port 80" I can't get past this. Any ideas? Thanks! Monty