Quote:
Originally Posted by nook_nerd
hi,
I tried to do the updat last nite, same way as i always have on my KA1, get firmware, sideload, then use KSM08 to do partial update, and it appears to load ok, but when i then attempt to use nickel, it tries to load it, i get 2 squares, then it drops back to KSM Menu..
I don't belive this is a KSM issue, just lookin for a way to debug it..
I am able to load prior firmware and KSM and KA1 loads nickel without any issues..
Any ideas? or do i need to prob do a full reset of the KA1?
Thanks all,
John Feole
|
I just installed 4.4.9298 to see whether I have the same problem. The first time I launched nickel it took extremely long, but finally it started. When I started nickel for the second time, nickel did not successfully load, but it did also not give control back to KSM (this is different from what your device does). This is bad. I replace KoboReader.sqlite by the backup-version, and was able to start nickel. When I tried it again, it did not work. It seems when the nickel writes to the database, it cannot start the next time.
Unfortunately, I am very busy and cannot look into this. Maybe in some week. Would be nice if somebody else could have a look at this problem.
Edit: I tried to start nickel via "tools" > "nickel diverse.msh" > "start nickel no fmon.sh," oddly nickel did start, and since then I can start nickel the normal way ("start nickel"). This might have been a fmon problem, related to nickel trying to create new thumb nails for the new home screen. I am not sure about this however.