MobileRead Forums - View Single Post - If I replace my logic board after water damage, can I clone my existing serial?

coplate · 04-26-2017, 10:52 PM

Yes, thanks for your response. this is the one that lasts about 2-3 days, wether I'm using it or if its in suspend, it seems to be drainign at in-use rate, even though the logs show it going to suspend, thats why I think I need a new logic board too - although the drain could be in the touchscreen too, that seems less likely, but I can't be sure.

What I have now is a PW3 that is jailbroken.

I have installed only KUAL and Usbnet so far.

I don't have any experience wit the rescue packs, but I can learn.

Edit: - I could enable sshd at boot and remove the screen assembly, to see if anything in that is draining. But I dont know what kind of battery drain having sshd does, will it prevent suspend even if I'm not connected?

04-26-2017, 10:52 PM	#3
coplate Guru Posts: 645 Karma: 1888888 Join Date: Jun 2009 Device: prs-505, Kindle Keyboard 3g, PW3	Yes, thanks for your response. this is the one that lasts about 2-3 days, wether I'm using it or if its in suspend, it seems to be drainign at in-use rate, even though the logs show it going to suspend, thats why I think I need a new logic board too - although the drain could be in the touchscreen too, that seems less likely, but I can't be sure. What I have now is a PW3 that is jailbroken. I have installed only KUAL and Usbnet so far. I don't have any experience wit the rescue packs, but I can learn. Edit: - I could enable sshd at boot and remove the screen assembly, to see if anything in that is draining. But I dont know what kind of battery drain having sshd does, will it prevent suspend even if I'm not connected? Last edited by coplate; 04-26-2017 at 11:08 PM.